The trench concrete reinforced firing position terrain model is approximately 110mm wide by 42mm high (average) by 94mm front to back, including scenery embankment. The internal dimensions of the trench are 33mm deep and 32mm wide on average, and will provide sufficient cover for most 25mm to 28mm wargames figures. The concrete reinforced firing positions come complete with terrain lids to assist in your wargame and the clear dimension (in which a figure must fit) is 38mm, which should suit most 25mm to 28mm wargaming figures in the firing position.
Buy individually or check out our discounted COMBI-DEAL for a 4ft length of trench.
The trench system is also suitable for 'near future' wargame scenarios as well as Warhammer 40k wargame terrain.
This terrain model is also suitable for 1/48 scale model dioramas.
During WW2 a network of trenches and ringstands could form a complex and effective defensive line. Urban Construct have put together a selection of wargames terrain trench sections, which begin to illustrate the complexity and variety of fortifications scenery. Trenches were used as firing positions or to connect between shelters, gun-emplacements, tobruks and observation posts within a strong point. These wargames terrain models are based on research into real and sometimes still existing installations.
During WW1 several trenches were run in parallel. From the frontline trench to the support trench and behind that the reserve trench.urban Construct produce wargames terrain trench sections, which are modular and will fit together so that you can form this type of WW1 scenery. Communication trenches ran at approximately right angles to these trenches to connect up the whole system.